Start Program Operating Modes - Dentsply Sirona Sinius Operating Instructions Manual

4 Operation
4.2 Control concept of touchscreen
56
4.2.2

Start program operating modes

After the treatment center is switched on, the Start program
automatically appears.
The start program can run in two operating modes. In the Standard
Start program operating mode, the functions of the patient chair and
instruments are each shown on separate screens. In the EasyMode
Start program operating mode, the patient chair and instrument
functions that are most important for the treatment are shown together
on the same screen.
You can set the operating mode that you want to work with in the
treatment center setup, see "Select Start program operating mode"
[→ 193]. The operating modes are described in detail below:
Standard Start program
In the Standard Start program , only the chair program function keys
and, in the case of a motor-driven headrest, the Move headrest in/out
function keys are displayed on the screen. The full range of functions of
the treatment center can be used in this operating mode.
All other chair functions are listed separately on the Manual Chair
Adjustment screen. This can be accessed via the Manual Chair
Adjustment key.
Other general functions of the treatment center are listed in the Start
sub-screen. This can be accessed via the Sub-screen key.
Dentsply Sirona
Operating Instructions Sinius
63 2 2 7 26 D3561
D3561.201.01.16.02 08.2018