Configuring Control Options; Preselecting The Number Of User Profiles; Setting The Cursor Control; Select The Operating Mode Of The Start Program - Dentsply Sirona Sinius Operating Instructions Manual

Dentsply Sirona
Operating Instructions Sinius
63 2 2 7 26 D3561
D3561.201.01.16.02 08.2018
4.14.4

Configuring control options

Operation of the entire treatment center operation can be configured in
this dialog.
➢ Touch the Control options key in the setup program.
Ä The sub-dialog opens.
4.14.4.1

Preselecting the number of user profiles

If fewer user profiles are required, their number can be limited so that
only the specified users can be selected after the treatment center is
switched on.
➢ Use the – and + keys to set the number of user profiles.
If the number of user profiles is limited to one, the User profiles key is
hidden in the start dialog.
4.14.4.2

Setting the cursor control

The cursor control can be set as follows:
● Field 1: Cursor control switched off
● Field 2: Cursor control switched on, without screen change
● Field 3: Cursor control switched on, with screen change:
For more information, please refer to "Using the cursor control" [→ 64].
ü A cable foot control is connected to the treatment center or a
wireless foot control is registered on the treatment center; see
"Setting the wireless foot control on the treatment center" [→ 61].
➢ Touch the Cursor control key.
Ä The selected field is highlighted orange.
4.14.4.3

Select the operating mode of the Start program

The Start program can run in two operating modes. In the operating
mode, Standard Start program , the functions of the patient chair and
instruments are each shown on separate screens. In the operating
mode, EasyMode Start program , the patient chair and instrument
functions that are most important for the treatment are shown together
on the same screen. For further details on the operating modes, see
"Start program operating modes" [→ 56].
➢ Touch the Start program operating mode key.
Ä If the key is highlighted orange, the EasyMode Start program is
displayed.
4.14 Configuration of the treatment center (setup)
4 Operation
193