X-Ray Tube Unit - Dentsply Sirona Sinius Operating Instructions Manual

4 Operation

4.11 X-ray tube unit

172
X-ray tube unit
4.11
The Sinius, Sinius CS, and Sinius TS treatment centers can be
equipped with the Heliodent Plus X-ray tube unit. However, for the
Sinius CS, this is possible only if the dentist element is mounted in the
standard position at the water unit, see section "Positioning the dentist
element" [→ 82].
The X-ray tube unit is attached to the light post of the treatment center
using a multi-jointed support arm that can be adjusted both horizontally
and vertically. Brakes in the support arm hold the X-ray tube unit in the
position to which it has been adjusted.
The X-ray parameters are set on the wall adapter of the X-ray tube unit
or on a "remote timer".
The USB module for the Xios XG intraoral X-ray system can be
connected to the PC via the USB interface on the dentist and assistant
element. For details, please refer to the section "USB interface" [→ 189].
WARNING
The X-ray tube unit can be positioned within the movement range of
the patient chair.
Moving the patient chair may cause the patient to collide with the X-
ray tube unit or its support arm. The patient could be injured.
➢ Before moving the patient chair, position the X-ray tube unit to
make a collision with the patient or the patient chair impossible.
CAUTION
Gaps appear between the internal hinges when moving the support
arm.
Fingers may be crushed in these gaps.
➢ Ensure that you never place your fingers in the gaps between the
hinges, neither during operation nor for cleaning purposes.
IMPORTANT
See also the Heliodent Plus operating instructions.
Dentsply Sirona
Operating Instructions Sinius
63 2 2 7 26 D3561
D3561.201.01.16.02 08.2018