Keysight E1458A Error Messages - Keysight VXI Bus 75000 C Series User And Programming Manual

C
Code Message
-101 Invalid character
-102 Syntax Error
-103 Invalid separator
-104 Data Type Error
-108 Parameter not allowed
-109 Missing parameter
-113 Undefined header
-124 Too many digits
-128 Numeric data not allowed
-131 Invalid suffix
-138 Suffix not allowed
-141 Invalid character data
-161 Invalid block data
-178 Expression data not allowed
-221 Settings conflict
-222 Data out of range
-224 Illegal Parameter Value
-240 Hardware Error
-410 Query Interrupted
-420 Query unterminated
-430 Query deadlocked
Keysight E1458A 96-Channel Digital I/O Module
User Guide

Keysight E1458A Error Messages

Cause
Unrecognized character in specified parameter.
Command is missing a space or comma between parameters.
Command parameters are not separated by a comma.
The wrong data type (i.e. number, character, string, expression) was used
when specifying a parameter.
Parameter specified in a command where none is allowed.
No parameter specified when required.
Command header was incorrectly specified.
>257 digits were specified for a parameter.
A number was specified for a parameter when a letter is required.
Parameter suffix incorrectly specified.
Parameter suffix is specified when one is not allowed.
The parameter type specified is not allowed.
Mismatch between character count in header and actual number of
characters.
A parameter is enclosed in parenthesis.
Digital I/O command settings are in conflict (e.g., control asserted when in a
handshake mode other than NONE).
Value specified is out of the legal range for parameter.
Inconsistent parameter value or block not found.
Hardware error detected during power-on cycle.
Return digital I/O module to Keysight Technologies for repair.
Data is not read from the output buffer before another command is issued.
Command which generates data not able to finish executing due to a digital
I/O module configuration error.
Command execution cannot continue since the mainframe's command input
and data buffers are full.
Clearing the instrument restores control.
143