Configuring for Installation
Installing the Keysight E1459A in a VXIbus Mainframe
1
Set the extraction levers out.
Extraction
Levers
4
Tighten the top and bottom screws to
secure the module to the mainframe.
NOTE: The extraction levers will not
seat the backplane connectors on older
VXIbus mainframes. You must manually
seat the connectors by pushing in the
module until the module's front panel is
flush with the front of the mainframe.
The extraction levers may be used to
guide or remove the
To remove the
reverse the procedure.
Keysight E1459A/Z2404B User and SCPI Programming Guide
The Keysight E1459A may be installed in any C-size VXIbus mainframe
slot (except slot 0). Refer to Figure 8 to install the module in a
mainframe.
2
Slide the
(except slot 0) until the backplane
connectors touch.
module
.
from the mainframe ,
module
Figure 1-8 Installing the Keysight E1459A in a VXIbus Mainframe
To prevent electric shock, tighten faceplate screws when
installing module into mainframe.
Installing and Configuring the E1459A
module
into any slot
3
Seat the
module
into the
mainframe by pushing in the
extraction levers
25