Scpi Command Reference - Keysight VXI Bus 75000 C Series User And Programming Manual

Keysight E1458A Command Reference
Optional Parameters. Parameters shown within square brackets ( [ ] ) are optional
parameters. (Note that the brackets are not part of the command and are not
sent to the instrument.) If you do not specify a value for an optional parameter,
the instrument chooses a default value. For example, consider the
DISPlay:MONitor:PORT? [<MIN | MAX | DEF>] command. If you send the
command without specifying a parameter, the command returns the number of
the port last addressed. If you send the MIN parameter or the DEF parameter,
the command returns 0. If you send the MAX parameter, the command returns
11. Be sure to place a space between the command and the parameter.
Keyword Substitutions
Some commands indicate a keyword substitution by showing the substitution in
square brackets and lowercase letters. (It is important to note that this modifies
the keyword and should not be confused with a parameter name.) For example,
in the SCPI command MEASure:DIGital:DATAn[:type], the keyword [:type] should
be replaced by one these parameters:
Linking Commands
Linking IEEE 488.2 Common Commands with SCPI Commands. Use a semicolon
( ; ) between the commands. For example:
Linking Multiple SCPI Commands. Use both a semicolon ( ; )and a colon ( : )
between the commands. For example:

SCPI Command Reference

The following sections describe the Standard Commands for Programmable
Instruments (SCPI) commands for the Keysight E1458A Digital I/O Module.
Commands are listed alphabetically by subsystem and within each subsystem.
62
–
:BYTE
– :WORD
– :LWORd or :LW32
– :LW64
– :LW96
*RST;DIG:CONT2 1 or DIG:CONT2:POL POS;*IDN?
DIG:DATA2:POL NEG;:DIG:DATA2:BIT1 1
Keysight E1458A 96-Channel Digital I/O Module User Guide
SCPI Command Reference