Using The Handshake Modes - Keysight VXI Bus 75000 C Series User And Programming Manual

Using the Handshake Modes

Using the Handshake Modes
Handshaking ensures correct transfer of data between devices. You must set
both the mode and the timing to establish correct handshaking. SCPI commands
support the following modes of handshaking:
These SCPI commands set the type of handshake mode used:
These SCPI commands set the timing of the handshake (where timing applies):
Handshake Modes
The operation of each handshake mode for input or output operations is
described in the following subsections. In these discussions, only the FLG, CTL,
and DATA lines are included. Other port control lines, controlled only through
register access, are described in Appendix B of this manual.
Keysight E1458A 96-Channel Digital I/O Module User Guide
– LEADing Edge
– TRAiling Edge
– PULSe
–
PARTial
–
STRobe
–
NONE
[SOURce:]DIGital:DATAn[:type]:HANDshake[:MODE] <mode>
[SOURce:]DIGital:HANDshaken[:MODE] <mode>
[SOURce:]DIGital:DATAn[:type]:HANDshake:DELay <time>
[SOURce:]DIGital:HANDshakenDELay <time>
Using the Keysight E1458A Digital I/O Module
35