[Source:]Digital:handshaken:delay - Keysight VXI Bus 75000 C Series User And Programming Manual

[SOURce:] Subsystem

[SOURce:]DIGital:HANDshaken:DELay

[SOURce:]DIGital:HANDshaken:DELay <time> sets the time between data valid
and the assertion of the control line to TRUE for port n. This form of the
command operates on 8-bit ports only.
Parameters
The controller uses a rounded-up value for <time> if these values are specified.
Keysight E1458A 96-Channel Digital I/O Module User Guide
Parameter Name Parameter Type
HANDshaken Numeric
<time> Numeric
Discrete
–
:HANDshaken is the keyword used for commands relating to data
handshaking at port n. The port number n must be the last character of the
keyword without spaces.
– The delay time must be set to the same value on all ports used in a
multiple-port operation.
– MAX sets a 15-ms delay. DEF sets 2-µs delay. MIN sets a delay of 0.
Because of hardware ambiguity at this delay setting, the actual delay is not
guaranteed. Note that MIN is illegal for PULSe or STRobe handshakes.
– This command sets the strobe pulse width for both input and output
STRobe handshakes.
– DIGital:HANDshaken NONE command ignores any programmed delay
time. For all other modes of handshaking, 2 µs is the minimum.
–
Specific bands of delay settings are not allowed. These are:
0 µ s > <time> < 2 µ s
15 µ s > <time> < 20 µ s
150 µ s > <time> < 200 µ s
1.5 ms > <time> < 2.0 ms
– Related Commands: [SOURce:]DIGital:HANDshaken[:MODE]
[SOURce:]DIGital:CONTroln:POLarity [SOURce:]DIGital:CONTroln[:VALue]
[SOURce:]DIGital:FLAGn:POLarity
–
*RST Condition: Delay is set to 2 µs.
Keysight E1458A Command Reference
Range of Values
0 through 11
µ µ
2 s to 15 s
µ µ
20 s to 150 s
µ
200 s to 1.5 ms
2ms to 15ms
MIN | MAX | DEF
Default
None
None
97