3.5
Loading and transporting
Attention
• When loading and subsequently transporting the machine to the
work site, the squeegee and brush head must be raised. Fresh
and waste water tank must be empty!
• Risk of skidding! Drive very carefully and, if possible, only on dry
ramps.
• To load the machine, reverse it up the ramp at idle speed
(maximum slope 16 %).
Loading
When loading the machine, observe its weight, see Section 4 Technical data.
A
D
Fig. 23:
Transporting
When transported on a vehicle or trailer, the machine must be secured against
tilting and rolling away. To do so, securely lash the machine on both sides at the
front Fig. 23-A, at the side Fig. 23-B (without side collision protection),
Fig. 23-C (with side collision protection) and at the rear Fig. 23-D with tension
straps.
03-7182-01.fm
B
Operation
C
D
59