Pushing The Machine - HAKO Scrubmaster B260 R Operating Manual

3.4.5

Pushing the machine

Danger
Risk of accident! When pushing the machine, it does not have any
braking effect.
Only push the machine on a level surface!
After pushing the machine, do not re-start until the lever(s) has
(have) been positioned and the cover has been fitted.
If the machine stops on an uphill or downhill gradient, call the towing
service or Hako service!
Fig. 22:
In order to push the machine, carry out the following steps:
1. Loosen the bolts of the cover to the drive using the supplied socket wrench
and remove the cover.
2. Remove the pin Fig. 22-A from the holder and screw it into the
ring Fig. 22-B.
3. In order to unlock the parking brake, pull the pin upwards slightly Fig. 22-C
and simultaneously push the machine.
If the machine has an X-AC drive, the rear wheel brake must also be
unlocked. To do so, push the lever at the rear on the right side of the machine
Fig. 22-D from right to left until it engages.
Indication appears on the multifunction display when the rear wheel brake is
taken out of service Fig. 22-E. The machine can no longer be driven!
Disassembly is in reverse order.
03-7182-01.fm
B
A
C
Operation
D
E
57