Information About Special Risks; Electrical System; Batteries - HAKO Scrubmaster B260 R Operating Manual

1.5

Information about special risks

1.5.1

Electrical system

• If the electrical system is faulty, always turn off the machine, disconnect the
battery and eliminate the fault.
• Work on the electrical system may be done only in accordance with
electrical engineering standards by a specialist trained for this work.
• Regularly inspect/check the electrical system of the machine. Defects such
as loose connections, loose nuts of electrified bolts, electrical components
or damaged cables must be eliminated immediately.
• Only use original fuses with the specified current. If stronger fuses are
used, the electrical system can be destroyed and fires may occur.
1.5.2

Batteries

• Observe the operating manuals and safety instructions provided by the
battery manufacturer.
• Never connect or disconnect batteries when the machine is turned on.
• Make sure the batteries are never fully discharged; recharge them as
quickly as possible.
• Only instructed maintenance personnel must handle and replace batteries.
• Only batteries approved by Hako may be used at the intended position.
• Danger! Make sure that the insulation of the battery cables is not damaged.
The battery cables should not rub against anything. If the insulation is
defective, no longer use the machine and have the battery cables replaced
by the Hako customer service immediately.
• Caution! Always make sure that the batteries are clean and dry to avoid
creeping currents and corrosion damage. Protect the batteries, in
particular, against conductive contamination, e.g. metal dust.
• Risk of short circuits and spark formation! Never place tools or other electri-
cally conductive objects on the battery!
• Do not remove insulating caps and covers, if necessary re-install them after
carrying out work on the battery cables.
01-7182-01.fm
Safety instructions
13