HAKO Scrubmaster B260 R Operating Manual page 90

Maintenance and Servicing
Height adjustment
The height adjustment (X) of the supporting rollers Fig. 51-A has been set to
7 mm in the factory. If striping still occurs despite optimum inclination adjust-
ment, readjust the distance between the supporting rollers and the lower edge
of the sealing strip.
Distance from floor (X) Use
<7 mm
7 mm
>7 mm
Fig. 51:
1. Place the machine on a level surface.
2. Lower the squeegee. The sealing strips must now be resting vertically onto
the floor.
3. Loosen nuts Fig. 51-B and adjust distance between supporting roller and
ground as per the table.
4. Tighten nuts.
90
Very smooth floor surfaces, e.g. coated screed,
PVC, linoleum
Standard setting
Very uneven floor surfaces, e.g. poorly laid tiles
(water does not drain off)
B
A
05-7182-01.fm