Transporting The Machine; Using A Trailer Or Transport Vehicle; Pushing Or Towing The Machine - HAKO PowerBoss Nautilus User Manual

TRANSPORTING THE MACHINE

USING A TRAILER OR TRANSPORT VEHICLE

1. Position the machine on the transport vehicle or
trailer and apply the parking brake.
2. Tie the machine down using the tie down bars on
both sides of the front corners and behind both rear
wheels.
Note: Attach the tie downs to the tie down bars only.

PUSHING OR TOWING THE MACHINE

Before towing or pushing the machine, turn the bypass
valve located on the top of the propulsion pump 90
degrees as shown. See Fig. 2.
CAUTION
The tow control valve must be turned 90 degrees
from the operating position.
Not turning the tow control valve will cause damage
to the pump.
Nautilus Rider Scrubber/Sweeper #988749UM Rev. K 04/21
© 2014-2015 Minuteman International, Inc.
ATTENTION!
Do not tow or push the machine a distance of more
than 0.5 mi (0,8 km) or faster than 1 mph (1,6 km/
hr). Exceeding these restrictions may cause damage
to the hydraulic system. If towing will exceed the
above restrictions, the rear wheel must be raised or
supported by a dolly.
Fig. 2: Bypass Valve locations
PowerBoss
®
The Power of Clean
BYPASS VALVE
IN NORMAL
OPERATING
POSITION
BYPASS VALVE
IN TOWING
POSITION
(90 DEGREES)
Page 43