Check And Correct Settings - HAKO Scrubmaster B260 R Operating Manual

6.4.2

Check and correct settings

A
B
With overhead guard
Fig. 62:
If the pre-sweep suction unit is attached to the machine and the lever is in the
sweeping position (Pos. 1) Fig. 61-A, the frame must be aligned parallel to
the floor.
If this is not the case, the following steps must be taken:
1. Disconnect the pre-sweep suction unit.
2. Unscrew the swivel bracket Fig. 61-B from the machine. The tilt angle of
the frame is determined by adding or removing the washers Fig. 61-C. The
following applies: the more the washers are used, the more the frame will
tilt downwards at the front.
06-7182-01.fm
Attachments/options
Without overhead guard
101