Interrupting Operation; End Of Operation; Transport Mode; Loading The Vehicle - HAKO Scrubmaster B100R Instruction Manual

First Operation
2.6

Interrupting operation

1. Release the throttle. – The vehicle
stops.
2. In the case of longer operation stop-
pages, turn the ignition key from (1)
to (0) and remove it from the key
switch.
3. If the vehicle is parked on sloping
ground, secure it from rolling away
by placing wheel chocks under the
wheels.
2.7

End of operation

1. Drive to an appropriate maintenance
area.
2. Turn the ignition key from (1) to (0)
and remove it from the key switch.
3. Empty the recovery tank and rinse
out, if necessary.
Observe the applicable laws
and local regulations when dis-
posing of cleaning agents.
4. Fill the solution tank and cleaning
agent in accordance with the manu-
facturer's mixing directives.
12
Only use cleaning agents suit-
able for the equipment (non-
foaming). We recommend us-
ing our clean and care prod-
ucts which are specially bal-
anced for the vehicles. These
products meet the require-
ments stipulated in the wash-
ing and cleaning agent direc-
tive.
If the machine is to be shut
down for a longer time, the so-
lution tank must be emptied.
5. Check the sealing strips and suction
hose.
6. Charge the battery.
7. Clean the vehicle if dirty.
It is not permitted to clean the
vehicle with a pressure washer
or steam blaster.
2.8

Transport mode

When driving on areas which do not
need to be scrubbed or vacuumed, set
the function selection switch to drive
mode. – Otherwise, there is unneces-
sary wear of the brushes and sealing
strips as well as use of the batteries.
2.9

Loading the vehicle

1. Empty the solution tank and recov-
ery tank.
2. Fix a strapping belt (Fig. 2/1) through
the eyelets behind the rear axle.
3. Lay another strapping belt (Fig. 2/2)
over the foot space.
4. Tension both strapping belts.
5. Secure the vehicle with wheel
chocks on all sides.
2
Fig.2
1