Roland R1000 Series Manual page 63

B0048191 / Rev. 1.5
Optocoupler inputs for fast measurements
For real-time measurements it is possible to start measurement with external optocoupler inputs.
The optocoupler function with a control voltage of 20 to 28 VDC. For connections see table on
page 40 "Pin configuration of voltage supply connection".
The combination of measurement start 1, 2 and 3 can be adjusted in the system configuration
menu.
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
Double Sheet Detector R1000 series UDK20
with integrated fieldbus interface
Signal
IN0
IN1
IN2
Note Measurement start signal can be issued either via the process
channel or via an optocoupler. Simultaneous measurement start
signals result in fault messages.
Manual
Meaning
External measurement start 1
External measurement start 2
External measurement start 3
Electrical installation
Note
1st optocoupler input
2nd optocoupler input
3rd optocoupler input
63