Roland R1000 Series Manual page 57

B0048191 / Rev. 1.5
5.2.3.3 DeviceNet (B-coded)
An M12 plug with inverse coding is used for the DeviceNet connection. A T-connector is not
necessary, because the control unit is equipped with input and output.
The corresponding cable plugs are part of the standard scope of supply. The power consumption of
the DeviceNet is 30 mA.
M12, 5-pin, B-coded, male connector at control unit
2
5
3
View: plug side
5.2.3.4 DeviceNet (A-coded)
An M12 plug with inverse coding is used for the DeviceNet connection. A T-connector is not
necessary, because the control unit is equipped with input and output.
The corresponding cable plugs are part of the standard scope of supply. The power consumption of
the DeviceNet is 30 mA.
M12, 5-pin, A-coded, male connector at control unit
2
5
3
View: plug side
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
Double Sheet Detector R1000 series UDK20
with integrated fieldbus interface
Note If the UDK20 is the last participant in the bus, then an external
termination resistor should be placed into the open connector.
The resistor is not included in the scope of supply.
Allocation of DeviceNet connection
Input (Pos. C2)
1
4
Suppliers / types / notes: Binder, type 715 (B-coded) and others
Note If the UDK20 is the last participant in the bus, then an external
termination resistor should be placed into the open connector.
The resistor is not included in the scope of supply.
Allocation of DeviceNet connection
Input (Pos. C2)
1
4
Suppliers / types / notes: Binder, type 715 (A-coded) and others
Manual
M12, 5-pin, B-coded, female connector at control unit
Pin 1 shield
Pin 2 V +
Pin 3 V -
Pin 4 CAN High
Pin 5 CAN Low
M12, 5-pin, A-coded, female connector at control unit
Pin 1 Shield
Pin 2 V +
Pin 3 V -
Pin 4 CAN High
Pin 5 CAN Low
Electrical installation
Output (Pos. C1)
1 2
5
4 3
View: plug side
Output (Pos. C1)
1 2
5
4 3
View: plug side
57