Motor / Motor Brake (Plug X3) - Parker Compax3 Series Operating Instructions Manual

Compax3 device description

Motor / Motor brake (plug X3)

3.1.6.

Motor / Motor brake (plug X3)

24
Connection of the power voltage of 2 Compax3 V4 devices (400V
devices)
In order to improve the conditions during brake operation, the DC power voltage of
2 devices may be connected.
The capacity as well as the storable energy are increased; furthermore the braking
energy of one device may be utilized by a second device, depending on the
application.
Please connect as follows:
Device 1 X2/4 to device 2 X2/4
Device 1 X2/5 to device 2 X2/5
Please note the following:
Caution! In case of non-compliance with the following instructions, the
device may be destroyed!
You can only connect two similar devices (same power supply; same rated
!
currents)
Connected devices must always be fed separately via the AC power supply.
!
PIN Description
1 U (motor)
2 V (motor)
3 W (motor)
4 PE (motor)
5 BR+ Motor holding brake
6 BR- Motor holding brake
Screening connection of the motor cable
The motor cable should be fully screened and connected to the Compax3 housing.
We offer a special shield connecting terminal as accessory item (see on page
134).
Connect the brake only on motors which have a holding
brake! Otherwise make no brake connections at all.
Motor holding brake output
Controller type
Voltage range
Maximum output current (short circuit
proof)
Motor cable (see on page 121)
I11 T11 192-120101 N6 - March 2004
Compax3
21 – 27VDC
1.6 A