Iec61131-3 - Parker Compax3 Series Operating Instructions Manual

Status values
6.8

IEC61131-3

90
Status of cycle time of the control program
Available in technology function:
Unit of
n/a
measurement
D/A monitor output
not possible
Remark:
Current cycle time [unit: 1=500 µs] of the control program
Status of maximum cycle time
Available in technology function:
Unit of
n/a
measurement
D/A monitor output
not possible
Remark:
Maximum cycle time [unit : 1=500 µs]
Very large values may occur here with the command "Save objects
permanently". Then the control program will no longer be executed for
the execution time (about 1.5 sec)
Setpoint for analog output 0
Available in technology function:
Unit of
n/a
measurement
D/A monitor output
possible
Remark:
Setpoint for analog output 0 (DA0 - X11/4); can be used as a DA
monitor.
This output must be previously activated to be able to access it. You
can do this in the ServoManager in the optimization window in the
partial window at the bottom left under DA monitor.
Convert the signal source to IEC61131.
Setpoint for analog output 1
Available in technology function:
Unit of
n/a
measurement
D/A monitor output
possible
Remark:
Setpoint for analog output 1 (DA1 - X11/3); can be used as DA monitor.
This output must be previously activated to be able to access it. You
can do this in the ServoManager in the optimization window in the
partial window at the bottom left under DA monitor.
Convert the signal source to IEC61131.
I11 T11 192-120101 N6 - March 2004
User level
D/A monitor:
measurement unit of the
reference value
User level
D/A monitor:
measurement unit of the
reference value
User level
D/A monitor:
measurement unit of the
reference value
User level
D/A monitor:
measurement unit of the
reference value
Object 50.3
T10, T11, T30, T40
standard
-
Object 50.4
T10, T11, T30, T40
standard
-
Object 634.4
T11, T30, T40
advanced
-
Object 635.4
T11, T30, T40
advanced
-