New Machine Zero Modes; Rs485 / Rs232 Interface; New Functions Of The Compax3 Software Tools; C3 Servomanager: Configuration, Setup And Optimization Of Compax3 - Parker Compax3 Series Operating Instructions Manual

Introduction
1.3.1.5
1.3.1.6
1.3.2.

New functions of the Compax3 software tools

1.3.2.1
10

New machine zero modes

Several new machine zero modes with limit switch: MN-Mode 1,2 7-10, 11-14,
!
17,18, 23-26, 27-30
New machine zero modes in connection with the feedback module F12 F12
!
(direct drives) and distance coded feedback system: MN-Mode 130 - 133
Limit switch can be configured
!

RS485 / RS232 interface

Compax3 objects can be read in and written via RS232 and RS485 (see on page
77).
In this chapter you can read about:
C3 ServoManager: configuring Compax3, setup and optimization ..................................................10
C3 MotorManager: configuration of almost any motors ...................................................................11
C3 IEC61131-3 - Debugger ............................................................................................................11
CoDeSys - IEC61131-3 – development tool .................................................................................11
CamEditor: Cam creation for C3 T40 ..............................................................................................11
C3 ServoManager: configuration, setup and optimization of
Compax3
A modified recipe array can be loaded separately (without complete download) into
the device.
Firmware - Download
The Compax3 firmware can only be modified resp. updated with the aid of the C3
ServoManager.
For this you will need a so-called "firmware-package" (File: .*.fwp).
Setup support
You can set up all Compax3 technology functions easily in the optimization
window.
I11 T11 192-120101 N6 - March 2004