External Ballast Resistors - Parker Compax3 Series Operating Instructions Manual

Parker EME
8.6

External ballast resistors

In this chapter you can read about:
Ballast resistor BRM8/01 ..............................................................................................................128
Ballast resistor BRM5/01 ..............................................................................................................128
Ballast resistor BRM6/02 ..............................................................................................................128
Ballast resistor BRM4/0x...............................................................................................................129
Hazards when handling ballast resistors!
Danger!
Housing temperature up to 200°C!
Dangerous voltage!
The device may be operated only in the mounted state!
The external ballast resistors must be installed such that contact with
the human body is prevented.
Install the connecting leads at the bottom.
Observe the instructions on the resistors (warning plate).
The ballast resistors are equipped with a 1.5m connecting lead.
Please note that the length must not exceed 2m
Ballast resistors for Compax3
Ballast resistor Device
BRM8/01 (100Ω Ω Ω Ω )
Compax3 S025 V2
Compax3 S038 V4
BRM5/01 (56Ω Ω Ω Ω )
Compax3 S063 V2
Compax3 S075 V4
BRM6/02 (33Ω Ω Ω Ω )
Compax3 S150 V4
BRM4/01 (15Ω Ω Ω Ω )
Compax3 S300 V4
BRM4/02 (15Ω Ω Ω Ω )
Compax3 S300 V4
BRM4/03 (15Ω Ω Ω Ω )
Compax3 S300 V4
I11 T11 192-120101 N6 - March 2004
Compax3 Accessories
sustained dynamic
60W 250W (<1s; ≥ 10s cooling time)
2300W (<0.4s; ≥ 8s cooling
180W
time)
570W 6900 W (<1s; ≥ 20s cooling
time)
6900 W (<1s; ≥ 20s cooling
570W
time)
8900W (<1s; ≥ 20s cooling time)
740W
18kW (<1s; ≥ 20s cooling time)
1500W
127