Removing And Replacing The Front Usb Cable And Connector In The 8335-Gtb; Removing The Front Usb Cable And Connector In The 8335-Gtb - IBM Power System S822LC Manual

Hide thumbs Also See for Power System S822LC:
Table of Contents

Advertisement

What to do next
Prepare the system for operation. For instructions, see "Preparing the 8335-GTB system for operation after
you remove and replace internal parts" on page 198.
Removing and replacing the front USB cable and connector in the
8335-GTB
Learn how to remove and replace the front USB cable and connector in the IBM Power System S822LC
(8335-GTB) system.

Removing the front USB cable and connector in the 8335-GTB

Learn how to remove and replace the front USB cable and connector in the IBM Power System S822LC
(8335-GTB) system.
Before you begin
Power off the system and place it in the service position. For instructions, see "Preparing the 8335-GTB
system to remove and replace internal parts" on page 195.
Procedure
1. Attach the electrostatic discharge (ESD) wrist strap.
Attention:
v Attach an electrostatic discharge (ESD) wrist strap to the front ESD jack, to the rear ESD jack, or to
an unpainted metal surface of your hardware to prevent the electrostatic discharge from damaging
your hardware.
v When you use an ESD wrist strap, follow all electrical safety procedures. An ESD wrist strap is
used for static control. It does not increase or decrease your risk of receiving electric shock when
using or working on electrical equipment.
v If you do not have an ESD wrist strap, just prior to removing the product from ESD packaging
and installing or replacing hardware, touch an unpainted metal surface of the system for a
minimum of 5 seconds.
2. Remove the disk drive and fan card. For instructions, see "Removing the disk drive and fan card
from the 8335-GTB" on page 39.
3. Locate the front USB cable and connector (A) and the power switch and cable (B). They connect
between the system backplane and the power switch along the inside of the system. See Figure 64 on
page 54. Label each cable.
Removing and replacing parts in the IBM Power System S822LC (8335-GTB)
53

Advertisement

Table of Contents
loading

This manual is also suitable for:

Power system 8335-gtb

Table of Contents