Removing The Front Usb Connector Board - IBM System x3530 M4 Installation And Service Manual

Removing the front USB connector board

To remove the front USB connector board, complete the following steps:
1. Read the safety information that begins on page Safety and "Installation
2. Turn off the server (see "Turning off the server" on page 21) and all attached
3. Remove the server cover (see "Removing the server top cover" on page 362).
4. Disconnect the USB cable from the connector on the rear of the USB assembly.
5. (For 2.5-inch hard disk drive models) Press the release tab and push the USB
6. (For 3.5-inch hard disk drive models) Press the release tab and push the USB
7. Remove the two screws from the USB assembly and rotate the front USB
336
System x3530 M4 Type 7160: Installation and Service Guide
v Set the system date and time.
v Set the power-on password.
v Reconfigure the server.
See "Using the Setup utility" on page 75 for details.
guidelines" on page 30.
peripheral devices. Disconnect all power cords; then, disconnect all external
cables as necessary to replace the device.
assembly toward the rear of the server.
assembly toward the front of the server.
connector board out of the USB assembly.