Data Logger - GE Power Quality Meter Series Instruction Manual

4 PROGRAMMING
]] SETPOINTS
]] S2 SYSTEM SETUP
] CURRENT/VOLTAGE
] CONFIGURATION
MESSAGE
MESSAGE
] PULSE INPUT
]
MESSAGE
MESSAGE

] DATA LOGGER

]
MESSAGE
MESSAGE
] END OF PAGE S2
]
Figure 4–20: SETPOINTS PAGE 2 – SYSTEM SETUP / DATA LOGGER
• STOP DATA LOG 1 / 2: The data logger operation is only configurable over the serial port using PQMPC
or other third party software. On occasions it may be necessary to stop the data loggers using the PQM
keypad and then a computer to extract the logged information. The STOP DATA LOG 1 and 2 setpoints
allow the user to stop the respective data log. These setpoints also display the current status of the respec-
tive data logger. Refer to the Appendix for a detailed description of the data logger implementation.
GE Power Management
SETPOINT
]] SETPOINTS
]] S3 OUTPUT RELAYS
MESSAGE
STOP DATA LOG 1:
NO (STOPPED)
STOP DATA LOG 2:
NO (STOPPED)
PQM Power Quality Meter
4.3 S2 SYSTEM SETUP
4.3.7 DATA LOGGER
Range: NO, YES
Range: NO, YES
4-33
4