Clock - GE Power Quality Meter Series Instruction Manual

4.2 S1 PQM SETUP
MESSAGE
MESSAGE
4
MESSAGE
MESSAGE
• SET TIME/DATE: These messages are used to set the time and date for the PQM software clock.
The PQM software clock retains an accurate time for power interruptions lasting up to one hour. A CLOCK NOT
SET alarm can be enabled so that an alarm will occur on the loss of clock data. The time and date are used for
all time-stamped data. If the clock has not been set, a ? will appear on the right-hand side of the displayed time
for all time-stamped data. Follow the steps shown below to set the new time and date.
VALUE
U S E T H E V A L U E
K E Y S T O S E L E C T
T H E U N D E R L I N E D
Q U A N T I T I E S
4-8
]] SETPOINTS
]] S1 PQM SETUP
] PREFERENCES
]
] FRONT PANEL RS232
] SERIAL PORT
] DNP 3.0
] CONFIGURATION

] CLOCK

]
Figure 4–6: SETPOINTS PAGE 1 – PQM SETUP / CLOCK
SET TIME hh:mm:ss
12:00:00 am DATE->
SET DATE mm:dd:yyyy
Jan 01, 1996
MESSAGE
SET DATE mm:dd:yyyy
Oct 01, 1996
PQM Power Quality Meter
SETPOINT
]] SETPOINTS
]] S2 SYSTEM SETUP
MESSAGE
SET TIME hh:mm:ss
12:00:00 am
SET DATE mm:dd:yyyy
Jan 01, 1996
MESSAGE
SET TIME hh:mm:ss
03:00:00 am DATE->
MESSAGE
NEW TIME
HAS BEEN STORED
MESSAGE
SET DATE mm:dd:yyyy
Jan 01, 1997
4 PROGRAMMING
4.2.6 CLOCK
DATE->
MESSAGE
SET TIME hh:mm:ss
03:35:00 am DATE->
MESSAGE
STORE
SET TIME hh:mm:ss
03:35:55 am DATE->
STORE
NEW DATE
HAS BEEN STORED
GE Power Management