Removing The Electrodes; Transferring The Ecg Data To A Pc; Compatible Evaluation Software - GE SEER 1000 Operating Manual

After Completing the Recording

Removing the Electrodes

CAUTION
RISK OF UNNECESSARY SKIN IRRITATIONS – After a long-term ECG ex-
amination, the electrodes may be tightly attached to the skin.
Slowly peel off the electrodes starting at their outer edge. Pull on the
plastic connectors only; never pull the cable leads to detach the snap
fasteners or plug-in connections from the ECG cable.

Transferring the ECG Data to a PC

NOTE
Do not disconnect the USB cable during data transfer.
NOTE
If you manually switch off the recorder while it is connected to your
computer's USB port, you must disconnect it from the USB port so
that it can power-down completely.
Use a USB cable to connect the recorder to a PC containing ECG analysis
and evaluation software.
As the recorders perform a series of internal tests after being s witched on,
you need to wait until the status LED lights up yellow before you can start
transferring data to your evaluation software. This may take up to 10 sec-
onds.
When you connect a recorder to the USB port of your computer, a USB
driver is installed. This process will be repeated if you connect the same
recorder to another USB port on the same computer.
Refer to the manual of the analysis and evaluation software for further in-
formation on transferring the ECG data.

Compatible Evaluation Software

The data stored by the devices are compatible with the GETEMED evalua-
tion software CardioDay 2.4 (and above) and the GE Healthcare MARS
Ambulatory ECG System, V8.0 SP3 (and above).
50 SEER™ 1000 2067634-077 Revision B