Clock; Programmable Message - GE Power Quality Meter Series Instruction Manual

5 MONITORING
]] ACTUAL VALUES
]] A2 STATUS
MESSAGE
MESSAGE

] CLOCK

]
TIME/DATE: The current time and date is displayed in this message. The PQM uses an internally generated
software clock which runs for at least one hour after the control power has been removed. To set the clock, see
setpoints page S1 PQM SETUP \ CLOCK. The S4 ALARMS/CONTROL \ MISCELLANEOUS \ CLOCK NOT SET ALARM alarm
occurs if power has been removed for longer than 1 hour and the clock value has been lost.
]] ACTUAL VALUES
]] A2 STATUS
MESSAGE
MESSAGE
] PROGRAMMABLE
] MESSAGE
MESSAGE
MESSAGE
] END OF PAGE A2
]
Figure 5–16: ACTUAL VALUES PAGE 2 – PROGRAMMABLE MESSAGE
A 40-character user defined message is displayed. The message is programmed using the keypad or via the
serial port using PQMPC. See S1 PQM SETUP \ PROGRAMMABLE MESSAGE for programming details.
GE Power Management
ACTUAL
MESSAGE
Figure 5–15: ACTUAL VALUES PAGE 2 – CLOCK
ACTUAL
MESSAGE
PHONE: 905-294-6222
GEindustrial.com/pm
PQM Power Quality Meter
]] ACTUAL VALUES
]] A3 POWER ANALYSIS
TIME: 12:00:00am
DATE: JAN 01 1996

5.3.4 PROGRAMMABLE MESSAGE

]] ACTUAL VALUES
]] A3 POWER ANALYSIS
5.3 A2 STATUS
5.3.3 CLOCK
5
5-23