Using Pqmpc; Entering Setpoints - GE Power Quality Meter Series Instruction Manual

6 SOFTWARE

6.5 USING PQMPC

The System Setup page will be used as an example to illustrate the entering of setpoints.
Select the Setpoint > System Setup menu item. The following window will appear:
When a non-numeric setpoint such as CT WIRING is selected, PQMPC displays a drop-down menu:
•
When a numeric setpoint such as NOMINAL INPUT DIRECT VOLTAGE is selected, PQMPC displays a keypad
•
that allows the user to enter a value within the setpoint range displayed near the top of the keypad:
Click Accept to exit from the keypad and keep the new value. Click on Cancel to exit from the keypad and
•
retain the old value.
Click on Store to save the values into the PQM. Click OK to accept any changes and exit the Setpoint / System
Setup dialog box. Click Cancel to retain previous values and exit.
GE Power Management PQM Power Quality Meter
6.5 USING PQMPC

6.5.1 ENTERING SETPOINTS

6
6-11