Relays - GE Power Quality Meter Series Instruction Manual

3 OPERATION
The status of the output relays is displayed with these indicators.
• ALARM: The ALARM relay is intended for general purpose alarm outputs. This indicator is on while the
ALARM relay is operating. If the ALARM is programmed as unlatched, this indicator flashes as long as the
alarm condition persists. When the condition clears, the ALARM indicator turns off. If the alarm relay has
been programmed as latched, the alarm condition can only be cleared by pressing the
issuing a computer reset command.
• AUX1: The AUX 1 relay is intended for control and customer specific requirements. The AUX 1 indicator is
on while the AUXILIARY 1 relay is operating.
• AUX2: The AUX 2 relay is intended for control and customer specific requirements. The AUX 2 indicator is
on while the AUXILIARY 2 relay is operating.
• AUX3: The AUX 3 relay is intended for control and customer specific requirements. The AUX 3 indicator is
on while the AUXILIARY 3 relay is operating.
GE Power Management PQM Power Quality Meter
3.2 STATUS INDICATORS

3.2.4 RELAYS

key or by
RESET
3
3-3