4.5.4
Data Logger
4–16
Select the Actual > Power Analysis > Trace Memory menu item to
view the trace memory data.
This launches the Trace Memory Waveform window.
The data logger feature allows the PQMII to continuously log various specified parameters
at the specified rate. The data logger uses the 64 samples/cycle data. This feature is
implemented into EnerVista PQMII Setup Software as shown below.
Select the Setpoint > System Setup > Data Log menu item to setup the
data logger feature.
This launches the Data Log settings box shown below. The state of each
data logger and percent filled is shown.
Use the Start Log 1(2) and Stop Log 1(2) buttons to start and stop the
logs.
CHAPTER 4: SOFTWARE
PQMII POWER QUALITY METER – INSTRUCTION MANUAL