ILX Lightwave LDX-3200 Series User Manual page 97

EXAMPLES "RAD dec" -action: the decimal radix is selected.
"rad hex; *ESR?" -action: the hexadecimal radix is selected; -response: #H80, means power-on
was detected.
¨ Front Panel
n Remote
The RADix? query allows the programmer to determine which radix type for status, condition, and event query
response data is currently selected. Decimal, binary, octal, and hexadecimal are allowed.
SYNTAX DIAGRAM
-where the character response data of DEC means decimal, BIN means binary, HEX means
hexadecimal, and OCT means octal.
POINTS OF
INTEREST DEC is the default type. The LDX-3200 Series Precision Current Source defaults to this radix at
power-up.
The RADix command is used to select the desired radix. Once it is changed, the new radix will
remain in effect until the power is shut off or a new RADix command is issued.
EXAMPLES "RAD?" -response: Dec, means the selected radix is decimal.
"rad?" -response: Hex, means the selected radix is hexadecimal.
"RADIX?" -response: Oct, means the selected radix is octal.
¨ Front Panel
n Remote
The SECURE command allows the service technician access to the protected user data command, *PUD,
which is a common command. This data is normally changed only at the factory, and therefore the SECURE
command is not needed by the user.
COMMAND REFERENCE
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
:
RAD
?
PAGE 52
RADix?
SECURE
CHPT 4