ILX Lightwave LDX-3200 Series User Manual page 68

¨ Front Panel
n Remote
The LASer:ENABle:COND? query returns the value of the status condition enable register of the LASER
operations.
SYNTAX DIAGRAM
:
-where the response is the sum of the following:
1 - LASER Current Limit
2 - LASER Voltage Limit
4 - N/A
8 - Power Limit
16 - Interlock Disabled
32 - N/A
64 – Compliance Voltage Limit
128 - Open Circuit
POINTS OF
INTEREST The enabled LASER conditions can be set by using the LASer:ENABle:COND command.
The LASER condition status can be monitored by the LASer:COND? query.
EXAMPLES "LAS:ENAB:COND?" -response: 17, means that the Laser Current Limit and Interlock disabled
LASER conditions will be reported (in summarized form) to the status byte (bit 3).
"Radix Hex; Laser:Enable:Cond?" -response: #H0F9B, means that all of the above conditions
will be reported (in summarized form) to the status byte (bit 3).
COMMAND REFERENCE
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
:
LAS ENAB
256 - Output is Shorted
512 - Output Changed to be In/Out of Tolerance
1024 - Output On/Off State
2048 - Ready for Calibration Data State
4096 - N/A
8192 - N/A
16384 - N/A
32768 - N/A
PAGE 23
LASer:ENABle:COND?
:
?
COND
CHPT 4