ILX Lightwave LDX-3200 Series User Manual page 65

o Front Panel
n Remote
The LASer:DISplay:MPD? query returns the status of the MDP (monitor diode power) measurement display
mode.
SYNTAX DIAGRAM
:
LAS
-where the response is 0 or 1.
POINTS OF
INTEREST In local operation, the status of the MDP measurement mode is indicated by the enunciator next
to the display (mW will be illuminated and not blinking when the display is in MDP
measurement mode).
EXAMPLES "LAS:DISp:MDp?" -response: 0, means that the MDP measurement is not displayed.
"Las:dis:MDP?" -response: 1, means that the MDP measurement is displayed.
n Front Panel
n Remote
The LASer:DISplay:PARAM command enables the display to show the parameter values.
SYNTAX DIAGRAM
:
PARAMETERS None.
POINTS OF
INTEREST This command has the same effect as pressing the (PARAMETER) SELECT switch while in
LASER mode. The selected parameter will be displayed for three seconds. The actual LASER
PARAM display is turned off automatically when a display selection is enabled.
Each time the command is issued, the next LASER parameter will be selected, see Chapter 2 for
more information.
COMMAND REFERENCE
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
: :
DIS
:
LAS DIS
PAGE 20
LASer:DISplay:MDP?
MDP
PPD
LASer:DISplay:PARAM
:
PARAM
?
CHPT 4