ILX Lightwave LDX-3200 Series User Manual page 78

n Front Panel
n Remote
The LASer:LIMit:I2? query returns the value of the LASER current limit for the 200 mA range on the LDX-
3220. (Not applicable for LDX-3210).
SYNTAX DIAGRAM
:
-where the response is the current limit value for the 200 mA range (LDX-3220).
POINTS OF
INTEREST The current limit is in effect in all modes of operation (ILBW, IHBW, or P). The current limit in
use depends on the LASER output range selection.
EXAMPLES "LAS:LIM:I2?" -response: 40, means the laser current limit is 40 mA.
"Laser:LIM:I2?" -response: 150, means the laser current limit is 150 mA .
n Front Panel
n Remote
The LASer:LIMit:I5 command sets the LASER current limit value for the 50 mA range on the LDX-3210 and the
500 mA range on the LDX-3220.
SYNTAX DIAGRAM
:
LAS
PARAMETERS An <nrf value> which represents the LASER limit current, in mA.
POINTS OF
INTEREST The current limit is in effect in all modes of operation (ILBW, IHBW, or P). The current limit in
use depends on the LASER output range selection.
In local operation, the limit current is entered by selecting LIM I parameter, pressing and
holding in the (PARAMETER) SET switch, adjusting the knob until the desired value is
displayed, and then releasing the SET switch.
EXAMPLES "LAS:LIM:I5 50" -action: the LASER current limit is set to 50 mA.
":Laser:Limit:I5 160" -action: the LASER current limit is set to 160 mA (LDX-3220 only).
COMMAND REFERENCE
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
:
LAS LIM
:
LIM
PAGE 33
LASer:LIMit:I2?
:
I2
LASer:LIMit:I5
<white
:
I5
space>
?
<nrf
value>
CHPT 4