Command Timing And Completion - ILX Lightwave LDX-3200 Series User Manual

Logical
OR
Turn Output Off
0- LASER Current Limit
1- LASER Voltage Limit
2- N/A
3- LASER Power Limit (output on)
4- N/A
5- N/A
6- N/A
7- N/A

Command Timing and Completion

This section describes, for each device-dependent command, whether that command is performed in an overlapped or
sequential manner. In other words, it states whether the next command may begin while this command is being
executed, or if the next command must wait until this command is completed before its execution begins. The
conditions for setting the operation complete flag are given in the Chapter 3 section titled Operation Complete
Definition.
OPERATING IN REMOTE CONTROL
CHPT 3
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
15 14 13 12 11 10 9 8
&
&
&
&
&
&
&
&
8
15 14 13 12 11 10 9
LASer:ENABle:OUTOFF <nrf>
LASer:ENABle:OUTOFF?
Bit Reference
8- N/A
9- LASER Output Changed to be out of Tolerance
10- N/A
11- N/A
12- N/A
13- N/A
14- N/A
15- N/A
Figure 3.3 LDX-3200 Series' Output Off Register
PAGE 10
LASER Output Off
7 6 5 4 3 2 1 0
&
&
&
&
&
&
&
&
7 6 5 4 3 2 1 0 LASER Output Off
Register
Enable Register