Guide For Hexadecimal Dumping Mode; Hexadecimal Dumping Function; Running Hexadecimal Dumping - SNBC BTP-L580IIC User Manual

4.10 Guide for hexadecimal dumping mode

4.10.1 Hexadecimal dumping function

This function prints the data transmitted from the host computer in hexadecimal numbers and
in their corresponding characters.
Print sample in Hexadecimal Dump mode:

4.10.2 Running hexadecimal dumping

1) Start hexadecimal dumping by executing either of the following:
a. Open the top cover, turn the power on while pressing the FEED button until the printer
alarms (LED flashes, buzzer beeps), and then close the top cover, then the printer will
enter hexadecimal dump mode. Please wait for the printer alarm after turning on the
power, otherwise the printer will not enter hexadecimal dump mode.
b. Execute the GS ( A command.
2) The printer first prints "Hexadecimal Dump To terminate .....", and then prints the received
print data in hexadecimal numbers and in their corresponding characters.
3) After printing has been finished, Hexadecimal dumping ends by executing any of the
following:
a. Turn the power off.
b. Press the FEED button three times.
Caution:
If no characters correspond to the data received, the printer prints "."
During hexadecimal dumping, any commands other than DLE EOT, DLE ENQ, or DLE DC4
do not function.
Insufficient print data to fill the last line can be printed by pressing down the FEED button.
- 12 -
BTP-L580IIC User's Manual