Main Frame L Assy - Brother HL-L5000D Service Manual

9.21 Main frame L ASSY

 For models with 520-sheet T1
(1) Remove the two taptite bind B M4x12 screws, and remove the under bar rear. (Touch
panel models only.)
(2) Remove the two taptite bind B M4x12 screws, and remove the under bar center. (Touch
panel models only.)
(3) Remove the two taptite bind B M4x12 screws, and remove the under bar front, under bar
cover and under bar ground plate R.
(4) Remove the two taptite bind B M4x12 screws, and remove the top bar rear. (Touch panel
models only.)
(5) Remove the taptite cup S M3x8 SR screw, and remove the under bar ground plate L.
(6) Remove the main PCB insulation sheet (transparent) and the main PCB insulation sheet
(black).
Assembling Note:
• Make sure that the black main PCB insulation sheet is inserted properly into the hole
of the transparent main PCB insulation sheet as shown in the illustration below.
(7) Turn the registration roller bushing on the registration roller shaft to the position as
shown in the figure below, and pull out the registration roller shaft.
Main PCB insulation
sheet (transparent)
Main PCB insulation
sheet (black)
Top bar rear
(Touch panel
models only)
Taptite bind
B M4x12
Under bar center (Touch panel models only)
Under bar rear (Touch panel models only)
Registration roller shaft
Fig. 3-69
3-80
Taptite cup S M3x8 SR
Under bar ground plate L
Registration roller
bushing
Taptite bind B M4x12
Under bar front
Under bar cover
Taptite bind B
M4x12
Under bar
ground plate R
Taptite bind
B M4x12
Confidential