Brother HL-L5000D Service Manual page 210

(3) Release each harness and flat cable securing fixture from each veil cover.
(4) Remove the screw cup M3x8 (black) screw, and remove the veil cover upper.
Note:
• For touch panel models, pull out the connector harness from the hole of the veil
cover upper.
(5) Disconnect the wireless LAN PCB. (Wireless LAN models only)
(6) Remove the screw cup M3x8 (black) screw, and remove the veil cover lower.
(7) Remove the four screw cup M3x8 (black) screws, and remove the main PCB ASSY.
Veil cover upper
Screw cup M3x8 (black)
Wireless LAN PCB
(Wireless LAN models only)
Screw cup M3x8 (black)
Screw cup M3x8 (black)
Harness routing: Refer to
Fig. 3-52
"3. Left side of the machine (Common to all
3-65
Main PCB ASSY
Veil cover lower
models)".
Confidential