Fuser Unit - Brother HL-L5000D Service Manual

2.2 Fuser unit

(1) Open the back cover.
(2) Push both ribs of the back cover in the direction of the arrows, and remove the two
bosses on the outer chute.
Note:
• Be careful not to damage the ribs inside the back cover.
Front cover
Rear nip release link
Assembling Note:
• When attaching the back cover, open the front cover and attach the back cover
while lifting the rear nip release link.
(3) Remove the back cover from the boss A, and remove the back cover.
(4) Open the outer chute approximately 80 degrees. Remove the outer chute from boss B,
and remove the outer chute from the machine.
Boss B
Boss A
Rib
Boss
Fig. 7-2
Fig. 7-3
7-3
Back cover
Outer chute
Outer chute
Boss B
Boss A
80°
Outer chute
Back cover
Boss
Rib
Confidential