7. IF YOU REPLACE THE MX / TT / LT
AND TT/LT CONTROL PCB
What to do after replacement
• Installing Firmware (Main Firmware)
• Adjusting Left-end and Upper-end Print Position (Function Code: 45) (TT only)
What you need to prepare
(1) One USB cable
(2) Create a temporary folder on the C drive of the computer (Windows
(3) Download utility (FILEDG32.EXE)
Copy this file into the temporary folder created on the C drive.
(4) Maintenance driver (MaintenanceDriver.zip)
When the maintenance driver is not installed on the computer, copy this file into the
temporary folder created on the C drive, and extract the copied file. Refer to
3 INSTALLING THE MAINTENANCE PRINTER DRIVER"
(5) Firmware
Main firmware
for the installation procedure.
djf file
(ex. 1LINE: D001GJ_A.djf or D001GH_A.djf,
Touch panel: D001GG_A.djf)
4-15
®
XP or later).
"APPENDIX
Confidential