Brother HL-L5000D Service Manual page 373


Adjust upper-end print position
<Function>
In the event that the upper-end print start position deviates, use this function to adjust the
position up and down. Adjustable range is -50 to 50 (1 unit = 0.084 mm = 300 dpi). (Shifted
down when the value is negative)
<Operating Procedure>
Non touch panel models
(1) Press the [▲] or [▼] key in the initial
state of maintenance mode to display
"MAINTENANCE 45" on the LCD, and
press the [OK] key. "USBNo." is
displayed on the LCD.
(2) Press the [▲] or [▼] key to display
"YAdjust" on the LCD, and press the
[OK] or [Go] key. "YAdjust MP" is
displayed on the LCD.
(3) Refer to <Adjustment option table>
the last page, press the [▲] or [▼] key
to select from the adjustment options,
and press the [OK] or [Go] key. "YAdj.
**= 0*" is displayed on the LCD.
(Selected option is shown for **.)
(4) To shift the writing start position down,
press the [▼] key to decrease the
value. To shift the position up, press
the [▲] key to increase the value.
(5) Press the [OK] or [Go] key after
adjusting the value. "Accepted" is
displayed on the LCD, and the
machine returns to the initial state of
maintenance mode.

Set HEXDUMP mode
<Function>
This function is used to enter HEXDUMP mode (hexadecimal mode) or not when the
machine starts next time.
Note:
• Do not turn this ON, otherwise the machine enters HEXDUMP mode when it starts. If it
is ON and the machine starts in HEXDUMP mode, you can return the machine to the
ready state by turning the power OFF then ON again.
Touch panel models
(1) Press the [4], and then the [5] key in
the initial state of maintenance mode.
"USBNo." is displayed on the LCD.
(2) Press the [▲] or [▼] key to display
"Y Adjust" on the LCD, and press the
[Mono] or [SET] key. "YAdjust MP" is
displayed on the LCD.
(3) Refer to <Adjustment option table>
the last page, press the [▲] or [▼] key
on to select from the adjustment options,
and press the [Mono] or [SET] key.
"YAdj. **= 0*" is displayed on the LCD.
(Selected option is shown for **.)
(4) To shift the writing start position down,
press the [▲] key to decrease the
value. To shift the position up, press
the [▼] key to increase the value.
(5) Press the [Mono] or [SET] key after
adjusting the value. "Accepted" is
displayed on the LCD.
(6) Press the [X] key to return the
machine to the initial state of
maintenance mode.
5-24
on
Confidential