Main Frame L Assy - Brother DCP-8110DN Service Manual

9.26 Main frame L ASSY

(1) Remove the two taptite bind B M4x12 screws, and remove the rear under bar from the
machine.
Note:
• Only DCP-8250DN, MFC-8950DW, MFC-8950DWT, MFC-8952DW and MFC-
8952DWT are equipped with a rear under bar.
(2) Remove the two taptite bind B M4x12 screws, and remove the front under bar and the
under bar earth plate R.
(3) Remove the taptite cup S M3x8 SR screw, and remove the under bar earth plate L from
the machine.
(4) Remove the main PCB insulation sheet (transparent) and the main PCB insulation sheet
(black) from the machine. Then pull out the duplex solenoid harness from the main PCB
insulation sheet (transparent).
(5) Turn the registration roller bushing of the registration roller to the position as shown in
the illustration below, and pull out the registration roller from the machine.
Main PCB insulation sheet (transparent)
Main PCB insulation sheet (black)
Taptite cup S M3x8 SR
Under bar
Taptite bind B
M4x12
Taptite bind
B M4x12
Under bar earth
plate L
Under bar earth plate R
Under bar
Fig. 3-116
3-87
Duplex solenoid harness
Registration roller
Registration roller bushing
Confidential