Brother HL-L5000D Service Manual page 217

(6) Remove the screw cup M3x8 (black) screw and two taptite bind B M4x12 screws.
Remove the low-voltage power supply PCB ASSY, and disconnect the low-voltage
power supply harness from the low-voltage power supply PCB ASSY.
Low-voltage power supply harness
Low-voltage power
supply PCB ASSY
Notch
Taptite bind B M4x12
Assembling Note:
• When attaching the low-voltage power supply PCB ASSY, engage the notch on the
low-voltage power supply PCB ASSY with the hook.
• Check that the heater harness is housed in the frame L as shown in the figure
below. Otherwise the harness may be caught in some sections of the machine,
and may catch fire.
Hook
Fig. 3-60
Notch
Heater harness
Fig. 3-61
3-72
Hook
Screw cup M3x8 (black)
Heater harness is
housed in frame L
Confidential