Brother HL-L5000D Service Manual page 40

Error
Description
codes
Rechecking the error after the power
switch was turned OFF and then ON
again because an error was detected
in the fuser unit. (This message is
6902
displayed for approximately 15
minutes when the machine is
restarted after error code 6901 has
occurred.)
Detected discharge that may be
6A00 attributable to dirty corona wire on the
drum unit.
6B01 ―
6B02 ―
6B03 ―
6B04 ―
6B0A ―
6C01 ―
6C02 ―
6C03 ―
6C04 ―
Detected more LTs than connectible
6D00
limit.
6E00 ―
Detected irregular power supply for
6F00
less than 100 times.
The eject sensor does not detect
7000 paper pass after the registration rear
sensor detected the paper pass.
7001 ―
7002 ―
7003 ―
7004 ―
Refer Error
to: codes
The eject sensor remains ON (paper
pass detected) even after the
2-54 7100
registration rear sensor detected the
end of paper pass.
2-54 7101 ―
7102 ―
7103 ―
7104 ―
7105 ―
7106 ―
When feeding from the MP tray, the
registration rear sensor does not
7200 detect paper pass within the specified
time after the registration front sensor
detected paper pass.
7201 ―
7300 ―
When printing from the paper tray 1,
the T1 paper feed sensor does not
7301 detect paper pass within the specified
time while the T1 paper empty sensor
detects some paper set.
When printing from the paper tray 1,
the registration front sensor does not
2-55 7302 detect paper pass within the specified
time after the T1 paper feed sensor
detected paper pass.
7400 ―
When printing from the paper tray 2, the
T2(LT or TT) paper feed sensor does not
2-55 7401 detect paper pass within the specified
time while the T2(LT or TT) paper empty
sensor detects some paper set.
When printing from the paper tray 2,
the registration front sensor or the
T2TT jam sensor does not detect
2-55 7402
paper pass within the specified time
after the T2(LT or TT) paper feed
sensor detected paper pass.
7500 ―
When printing from the paper tray 3, the
T3(LT or TT) paper feed sensor does not
7501 detect paper pass within the specified
time while the T3(LT or TT) paper empty
sensor detects some paper set.
When printing from the paper tray 3,
the registration front sensor or the T2/
T3TT jam sensor does not detect
7502
paper pass within the specified time
after the T3(LT or TT) paper feed
sensor detected paper pass.
When printing from the paper tray 4, the
T4(LT or TT) paper feed sensor does not
7601 detect paper pass within the specified
time while the T4(LT or TT) paper empty
sensor detects some paper set.
2-14
Description
Confidential
Refer
to:
2-56
2-56
2-57
2-57
2-58
2-59
2-60
2-61
2-62