Touch Panel Models - Brother HL-L5000D Service Manual

3.2.2 Touch panel models

Error message
First line
Cartridge Error
Cooling Down
Cover is Open
Drum !
Firmware Update You must update the
Ignore Data
Jam 2-sided
Jam Inside
Second line
Put the Toner
Cartridge back in.
Wait for a while.
-
-
firmware.
Press Stop[x].
Ignore Data
-
-
2-29
Description
The new toner sensor could not
detect the new toner cartridge
correctly.
The side thermistor of the fuser
unit or internal temperature sensor
detected a temperature higher
than the specified value.
The front cover sensor detected
that the front cover was open.
The eject sensor detected that the
fuser cover was open.
MX back cover sensor detected
the open cover when the MX was
selected as the output tray (before
registering printing data to
engine).
MX back cover sensor detected
the open cover when the MX was
selected as the output tray (after
registering printing data to
engine).
Detected discharge that may be
attributable to dirty corona wire on
the drum unit.
Firmware version of the main PCB
is older than that of the TT, MX
and LT.
Detected undecodable data during
printing. Received undecodable
PS data.
The registration front sensor does
not detect paper pass within the
specified time after the first side
was printed in duplex printing
mode.
The eject sensor does not detect
paper pass after the registration
rear sensor detected the paper
pass.
Error Refer
codes to:
4F01 2-50
6801 2-53
6001 2-51
6004 2-52
8808 2-74
8809 2-74
6A00 2-54
9400 2-79
--- 4.11.1
7800 2-66
7000 2-55
Confidential