Brother HL-L5000D Service Manual page 310

Assembling Note:
• When assembling the T2TT after disassembling the whole TT unit, the top plate front or
top plate rear may not be attachable. Loosen the screw securing each TT unit to attach
the top plate front or rear and tighten all screws after attaching the T2TT without fail.
(4) Loosen the clamp, and release the T2TT relay harness from the securing fixtures.
(5) Remove the four screw cup M3x8 (black) screws and the four flywheel lock washers
from the Top plate front. Remove the eight taptite cup S M3x8 SR screws, the two taptite
bind B M4x10 screws, and the two screw cup M3x8 (black) screws to remove the T2TT
unit.
Top plate rear
Taptite cup S M3x8 SR
T2TT relay harness
Taptite bind B M4x10
Clamp
T2TT relay harness
Harness routing: Refer to
Taptite cup S M3x8 SR
Screw cup M3x8 (black)
Flywheel lock washers
Taptite bind B M4x10
Screw cup M3x8 (black)
Taptite cup S M3x8 SR
Fig. 3-161
"13. Left side of the
3-165
Taptite cup S M3x8 SR
Taptite cup S M3x8 SR
Top plate front
Taptite cup S M3x8 SR
TT".
Screw cup M3x8 (black)
Flywheel lock washers
T2TT unit
Taptite cup S
M3x8 SR
Taptite cup S
M3x8 SR
Screw cup M3x8
(black)
Confidential