Brother HL-L5000D Service Manual page 65

Error message
First line
Print Unable E1 Turn the power off and
then back on again.
Print Unable E5 Turn the power off and
then back on again.
Print Unable E6 Turn the power off and
then back on again.
Print Unable E7 Turn the power off and
then back on again.
Print Unable E9 Turn the power off and
then back on again.
Print Unable ZC Turn the power off and
then back on again.
Replace Toner -
Screen Init. Fail Remove any material
which is on the
touchscreen.
Self-Diagnostic Turn the power off,
then on again.
Leave the machine for
15 min.
Will automatically
restart within 15
minutes.
Size Error Specify the correct
paper size for Tray1.
Specify the correct
paper size for Tray2.
Specify the correct
paper size for Tray3.
Second line
Program error
Detected an error in the main
PCB.
Detected an error in the main
PCB.
Detected an error in the main
PCB.
An error occurred while initializing
the NFC.
Detected irregular power supply
for less than 100 times.
Dot counter or develop roller
counter of the toner has reached
the upper limit.
An error occurred while initializing
the touch panel.
An error occurred in the fuser unit
when the power switch was turned
ON or sleep mode was released.
Rechecking the error after the
power switch was turned OFF and
then ON again because an error
was detected in the fuser unit.
(This message is displayed for
approximately 15 minutes when
the machine is restarted after error
code 6901 has occurred.)
When printing from paper tray 1, a
paper size not supported for paper
tray 1 was specified from the
driver.
When printing from paper tray 2, a
paper size not supported for paper
tray 2 was specified from the
driver.
When printing from paper tray 3, a
paper size not supported for paper
tray 3 was specified from the
driver.
2-39
Description
Error Refer
codes to:
E100 2-82
E500 2-83
E600 2-83
E701 2-83
E702 2-83
E900 2-83
6F00 2-55
4C01 2-50
D800 2-82
6901 2-54
6902 2-54
9702 2-80
9703 2-80
9704 2-80
Confidential