Brother HL-L5000D Service Manual page 122

 Paper jams in the ejecting section
<User Check>
• Check that the paper is set in each paper tray correctly.
• Flip over the paper in each paper tray or rotate the paper 180°.
• Adjust the paper guide according to the paper size.
• Check that there is not too much paper set in each paper tray.
• Check that the thickness of the paper is 60 to 105 g/m
• Flip through the paper and reset it in each paper tray.
Step
Foreign object in the rear of the
1
machine
2 Eject actuator coming off
Connection failure of the eject
3
sensor harness
Connection failure of the eject
4
motor harness
Connection failure of the MX
5
motor harness
Connection failure of the MX
6
switching solenoid harness
7 Fuser cover attachment failure
MX switching flapper
8
attachment failure
9 Eject sensor failure
10 MX switching solenoid failure
11 Eject motor failure
12 MX motor failure
Damaged gears in the ejecting
13
system
14 Damaged gears inside the MX
15 Fuser unit failure
16 Main PCB failure
Cause
Remove the foreign object.
Reattach the eject actuator.
Reconnect the eject sensor harness.
Reconnect the eject motor harness.
Reconnect the MX motor harness.
Reconnect the MX switching solenoid harness.
Reattach the fuser cover.
Reattach the MX switching flapper.
Replace the eject sensor PCB ASSY.
Replace the MX switching solenoid.
Replace the eject motor.
Replace the MX motor.
Replace the main frame L ASSY.
Replace the MX.
Replace the fuser unit.
Replace the main PCB ASSY.
2-96
2
.
Remedy
Confidential