Fuser Drive Gear 39 - Brother HL-L5000D Service Manual

9.28 Fuser drive gear 39

(1) Remove the three taptite bind B M4x12 screws, taptite cup S M3x8 SR screw (A), and
two taptite cup S M3x8 SR screws (B). Release the two hooks to remove the main PCB
shield calking ASSY from the main frame L ASSY. Pull out the eject motor harness from
the hole of the main PCB shield calking ASSY.
Note:
• Screw A is not equipped for models with 250-sheet T1.
• Do not allow the metallic gear shaft of the main PCB shield calking ASSY to face
down. Failure to observe this may cause the steel plate to bend.
Taptite bind B
M4x12
Hooks
Assembling Note:
• When securing the main PCB shield calking ASSY with screws, tighten the screws in
the sequence of the numbers engraved on the main PCB shield calking ASSY.
Eject motor harness
Main PCB shield calking ASSY
Fig. 3-79
3-90
Taptite cup S M3x8 SR (B)
Taptite cup S M3x8 SR (A)
Main PCB shield calking ASSY
Main frame L ASSY
5
4
2
1
3
Confidential