Pc Software Interface In Mtc10 Mode - Danfoss VLT5000 SyncPos Operating Instructions Manual

MG.10.J8.02 - VLT is a registered Danfoss trade mark
Chapter 5 a
Programmable SyncPos motion controller

■ ■ ■ ■ ■ PC Software Interface in MTC10 Mode

■ ■ ■ ■ ■ Operation Mode: Offline or Online ........................... 83
■ ■ ■ ■ ■ Opening SyncPos in MCT10 Mode .......................... 83
■ ■ ■ ■ ■ Closing SyncPos in MCT10 Mode ............................ 83
Manual closing ................................................................................ 83
Automatic closing ......................................................................... 83
■ File Handling ..................................................................... 83
■ "FILE" menu in MCT10 Mode ...................................... 84
"FILE" → "NEW" ............................................................................... 84
"FILE" → "OPEN" ............................................................................ 84
"FILE" → "SAVE AS" ..................................................................... 84
"FILE" → "PRINT" and → "PRINT SETUP" ................... 84
"FILE" → "LAST FILE" .................................................................. 84
■ "DEVELOPMENT" menu in MCT10 Mode ............... 84
Online Mode ....................................................................................... 84
Offline Mode ........................................................................................ 84
"DEVELOPMENT" → "SYNTAX CHECK" ........................ 84
"DEVELOPMENT" → "COMMAND LIST" ........................ 84
■ CAM Editor in MCT10 Mode ....................................... 85
■ CAM-Editor window without curve data ................. 85
"FILE" menu (CAM-Editor) in MCT10 Mode ................... 85
"EDIT" menu (CAM-Editor) in MCT Mode ....................... 86
"VIEW" menu (CAM-Editor) in MCT Mode ...................... 86
■ "SETTINGS" menu in MCT10 mode .......................... 86
81